Hadn't burned any DVDs in a while and have ran a few windows updates since, tried to burn a DVD and Roxio was only listing my CDR drive (always listed both, but I hadn't paid enough attention lately to notice when the one disapeared). When I reinstalled it, windows is listing it as a CD drive even with a DVD in it [though it does recognize it has a DVD, and the prompt comes up when I install a blank].
Reads both formats fine, but it won't even burn a CD [at least via Roxio 6 Platinum]
Plextor 712A DVD/CD burner
Generic CD burner (this works fine reading and burning)
Installed new 712A (actually refurb), updated Roxio, updated firmware, rearranged cables & jumpers, new cable, tried running just the combo drive.....still nothing.
Any ideas?
I'm running XP-Pro on a Supermicro P4SCT (P4 3.2).
My primary Raids feed an Adaptec SCSI controller
Backup drives on the SATA controller.
3 1/2 Floppy. I had both burners on one cable to IDE channel 0, but I've tried about every possible configuration and no difference.
Any ideas? I'd be glad to look stupid if I can get this thing to work again!
Reads both formats fine, but it won't even burn a CD [at least via Roxio 6 Platinum]
Plextor 712A DVD/CD burner
Generic CD burner (this works fine reading and burning)
Installed new 712A (actually refurb), updated Roxio, updated firmware, rearranged cables & jumpers, new cable, tried running just the combo drive.....still nothing.
Any ideas?
I'm running XP-Pro on a Supermicro P4SCT (P4 3.2).
My primary Raids feed an Adaptec SCSI controller
Backup drives on the SATA controller.
3 1/2 Floppy. I had both burners on one cable to IDE channel 0, but I've tried about every possible configuration and no difference.
Any ideas? I'd be glad to look stupid if I can get this thing to work again!
