WTB: Flexitor arm

[treeeman00]

Hey guys, im posting this again as I was unsuccessful in finding a used flexitor arm for my sv 252 skidozer. I am looking for a intermediate flexitor arm. If anyone has one they want to sell please let me know. Im trying to avoid buyung a new one as I will have to weld the arm to the splined axle (whats left of the splines).

 

[dep6113]

do you have a picture of yours? dimensions ? I have a couple of old ones with bad splines from my sv 200 rebuild

 

[treeeman00]

The arm is 7.5 inches long, 1.5 inches wide, axle is 1.5 inches wide, axle spline is 1 inch, axle is 5.5 inches long thread end to arm

 

[dep6113]

here is a picture of the old ones i have, 5.5 long and 1.5 diameter of the axle are the same. the shape is different so the 7.5 measurement is a bit off but real close. Wedding band for the bearing and seal are worn. yours if you want it, We are real busy at work might take me a few days to get to the post office to mail it out. send me and address.
Dave

 

[MNoutdoors RIP]

here is a picture of the old ones i have, 5.5 long and 1.5 diameter of the axle are the same. the shape is different so the 7.5 measurement is a bit off but real close. Wedding band for the bearing and seal are worn. yours if you want it, We are real busy at work might take me a few days to get to the post office to mail it out. send me and address.
Dave

Even though they look different they should work for him, they can be welded they are ductal iron not cast iron

 

[treeeman00]

thanks boggie. It sounds good