WTB: Cushman Trackster w/ Canopy

[markemery]

Looking to purchase Trackster with fiberglass cab. Preferably running and with 4-stroke. Also looking to buy snowplow attachment, but not mandatory.

If you are familiar with these, what should I expect to pay?

Thanks

 

[Snowtrac Nome]

a lot them little rigs command a high price

 

[NorthernRedneck]

Not sure if Nikson sold his yet. He did a very nice resto on one and had it listed here afterwards.

 

[Leadejon]

I just sold mine last week for $5500 all gone through with new tracks, all bogie bearings checked out, new seals in hydro, sealed gas tank, sprayed on green raptor liner, and installed a Polaris ATV 425 magnum motor. The engine fit great and turned about the same rpm as the 2 stroke so didn't loose any speed and had good power. No cab, plow or anything extra. I tryed to up load a pic see if it worked.

 

[Leadejon]

Another picture of engine install

 

[Bobmog]

Here is one:
https://wyoming.craigslist.org/sno/4380022897.html

 

[CRockett]

Look in Craigslist for eastern oregon, (Brogan) Has your wishlist at $6500.

 

[markemery]

Yeah, I spoke to him last week. Need to get the price down before I can make the 15 hour RT drive. Side windows look like they could be taped plastic. Noticed that after I talked to him. Thanks for the lead Crockett.

 

[borjeb]

Where are you at? I have a trackster I might be willing to apart with. It has an Onan 4 cycle engine (albeit a touch low on power). It doesn't have the fibreglass cab but it has a roll cage. It is in Alberta Canada

 

[humpmaster]

there is one posted under for sale that has a cab the owner is asking $1500 for it, someone else posted he was looking to buy, I also posted a repair manual for the tracksters as well as a supplement 1975, check it out!

Looking to purchase Trackster with fiberglass cab. Preferably running and with 4-stroke. Also looking to buy snowplow attachment, but not mandatory.

If you are familiar with these, what should I expect to pay?

Thanks

 

[humpmaster]

Very nice! but $5500that's a ton of dough for a tracked toy but you did a nice job and glad to here you got top dollar for it, I am sure you have way more time and money into it but hey that's what we do right? refurbish the past and that takes time and money, not to mention a ton of research finding parts etc.. again nice job!

I just sold mine last week for $5500 all gone through with new tracks, all bogie bearings checked out, new seals in hydro, sealed gas tank, sprayed on green raptor liner, and installed a Polaris ATV 425 magnum motor. The engine fit great and turned about the same rpm as the 2 stroke so didn't loose any speed and had good power. No cab, plow or anything extra. I tryed to up load a pic see if it worked.